Cabot's Cabothane Clear Non Drip Water Based

Cabot’s Cabothane Clear Non Drip Water Based is a highly durable, low odour, non drip clear timber varnish for interior doors, windows and furniture. It is designed specifically for interior vertical and fiddly surfaces where a non drip formulation will give a more satisfactory result.
  • Water Repellent
  • Fast Recoat 2 Hours
  • Non Yellowing Product
  • UV Protection
  • Areas
    Doors, Furniture, Trim, Windows
  • Clean Up
    Water
  • Sizes
    500ML, 1L
  • Sheen
    Satin
  • Coverage
    16 M2/L
  • Recoat Time
    2 Hours
  • Safety Data Sheet
Preparation

Note: Fill nail holes, cracks and other defects with Cabot's Woodtone Putty after applying the first coat of this product for accurate colour matching. Remove stains, dirt, wax, grease and oil with mineral turpentine. Remove any polish with a suitable polish remover.

Note: Previously coated interior timber with highly visible scratches, imperfections or surfaces that are severely worn must be sanded prior to coating. Bare Interior Timber Sand the surface smooth using 180 - 240 grit sandpaper. Sand only in the direction of the grain. Remove all traces of sanding dust.

New Bare Timber

Sand the surface smooth using 180 - 240 grit sandpaper. Sand only in the direction of the grain.

Remove all traces of sanding dust.

Previously Coated Interior Timber

  1. Thoroughly clean the surface with Cabot's Floor Clean and allow to dry.

  2. Apply one coat to a small test area. Allow to dry for 2 hours. Press sticky tape firmly to the surface and pull off quickly. If the coating comes off,sand back further to a sound surface.

Apply with Brush, Roller
Application
  1. Stir thoroughly with a broad flat paddle before and during use. Do not shake the can.

  2. Apply with a good quality brush or short nap roller. Always apply in the direction of the grain.

  3. Allow to dry for a minimum of 2 hours. For best results, lightly sand to remove any grain raise using 240 grit paper. Remove all sanding dust.

  4. Apply 2nd & 3rd coat as above.

  • Regularly check your coated timber for scratches, and signs of wear and tear.

  • When required, clean the surfaces with Cabot’s Floor Clean as per label instructions, and recoat with 2-3 coats of Cabot’s Cabothane Clear Non Drip for a longer lasting finish.

Sheen

Satin

Available sizes

500 ML
1 LITRE

Product Calculator

If you are unsure on how much product you need, please use our product calculator. Please note minimum length/width value is 1 metre and maximum is 50 metres.

1metre
1metre
2coats
Calculate
0 Total SQM
  • 0 SQM
  • 0 Litre