Products

Products

Cabot's Cabothane Clear Oil Based

Give your floors the TLC they deserve with Cabot's Cabothane Clear Oil Based. This clear polyurethane has been specially designed to be used on doors, windows, trim and furniture. Durable and hard wearing, this varnish will enhance the natural grain of timber, bringing it back to its very best.
  • Turps Wash Up
  • Areas
    Door, Furniture, Trim, Windows
  • Clean Up
    Turps
  • Sizes
    300G, 250ML, 500ML, 1L, 4L
  • Sheen
    Matt, Satin, Gloss
  • Coverage
    16 M2/L
  • Recoat Time
    6 Hours
  • Material Data Sheet Gloss
  • Material Data Sheet OB Satin
  • Material Data Sheet WB Satin
Preparation

Note: Fill nail holes, cracks and other defects with Cabot's Wood Tone Putty after applying the first coat of this product for accurate colour matching. Remove stains, dirt, wax, grease and oil with mineral turpentine. Remove any polish with a suitable polish remover.

BARE EXTERIOR TIMBER

To coat new bare timber immediately, scrub damp timber with Cabot’s New Timber Prep, following label instructions. New Timber Prep will draw out tannins and oils quickly from the surface, allowing you to skip the 4-6 weeks weathering process required for new timber. Always follow New Timber Prep with Cabot’s Deck Clean following label instructions.

PREVIOUSLY COATED INTERIOR TIMBER

1. Thoroughly clean the surface with Cabot's Floor Clean and allow to dry. Sand with 180 - 240 grit sandpaper and remove all traces of sanding dust.

2. Apply one coat to a small test area. Allow to dry for 6 hours. Press sticky tape firmly to the surface and pull off quickly. If the coating comes off, sand back to bare timber.

3. If coating adheres well, sand the entire area with 180 - 240 grit paper for good adhesion, remove dust, then follow application instructions.

Apply with Brush, Spray
Application

Note: Do not shake can.

1. Stir thoroughly with a broad flat paddle before and during use.

2. Apply with a good quality brush or spray gun. If spraying, back brushing is recommended. If brushing, always brush in the direction of the grain.

3. Allow to dry for a minimum of 6 hours then lightly sand using 240 grit paper. Remove all sanding dust.

4. Apply the 2nd & 3rd coats as above, lightly sanding with 240 grit paper between each coat.

Once your coating has worn and deteriorated, it's time for a re-coat.

1. Thoroughly clean the surface with Cabot's Floor Clean and allow to dry. Sand with 180 - 240 grit sandpaper and remove all traces of sanding dust.

2. Apply one coat to a small test area. Allow to dry for 6 hours. Press sticky tape firmly to the surface and pull off quickly. If the coating comes off, sand back to bare timber.

3. If coating adheres well, sand the entire area with 180 - 240 grit paper for good adhesion, remove dust, then follow application instructions.

Sheen

Matt
Satin
Gloss

Available sizes

300 GRAM
250 ML
500 ML
1 LITRE
4 LITRE

Product Calculator

If you are unsure on how much product you need, please use our product calculator. Please note minimum length/width value is 1 metre and maximum is 50 metres.

1metre
1metre
2coats
Calculate
0 Total SQM
  • 0 SQM
  • 0 Litre