Cabot's CFP Floor Water Based

Cabot's CFP Floor Water Based is a clear flooring polyurethane suitable for all interior timber parquetry and cork flooring. Highly durable, it’s been formulated to be hard wearing and has a fast drying finish. No sanding is required on pre-coated timber, saving you a time and hassle.
  • Fast Recoat 2 Hours
  • Non Yellowing Product
  • Water Wash Up
  • Areas
    Floors, Solid Timber, Cork, MDF
  • Clean Up
    Water
  • Sizes
    1L, 4L, 10L
  • Sheen
    Matt, Satin, Gloss
  • Coverage
    16 M2/L
  • Recoat Time
    2 Hours
  • Safety Data Sheet
  • CFP WB Satin Slip Resistance Certificate
Preparation

^ No sanding required.

No sanding is required for pre-coated timber floors, preparation steps below must be followed. Please note new timber must be sanded.

Remove stains, dirt, wax, grease and oil with mineral turpentine.

Remove any polish with a suitable floor polish remover.

Note: Floors with highly visible scratches, imperfections or floors that are severely worn must be sanded prior to coating.

Bare Timber

Sand the surface smooth using 180 - 240 grit sandpaper. Sand only in the direction of the grain. Remove all traces of sanding dust.

Previously coated floors & timber floating floors

Thoroughly clean the surface with Cabot's Floor Clean and allow to dry. Apply one coat to a small test area. Allow to dry for 3 hours. Press sticky tape firmly to the surface and pull off quickly. If the coating comes off, sanding back to a sound surface will be required.

Note: Fill nail holes, cracks and other defects with Cabot's Wood Tone Putty after applying the first coat of this product for accurate colour matching.

Apply with 6-10mm nap roller, Brush, Pad applicator
Application

Note: Do not shake can.

1. Stir thoroughly with a broad flat paddle before and during use.

2. Use a brush to cut in around the edge of one section at a time.

3. Apply product with a pad applicator, good quality brush or 6 - 10mm nap roller. Coat along the length of 3 - 4 boards, keeping a wet edge to prevent lap marks.

4. Allow to dry for a minimum of 3 hours. For best results, lightly sand to remove any grain raise using 240 grit paper. Remove all sanding dust.

5. Apply the 2nd & 3rd coats as above.

BARE TIMBER FLOORS

Apply 3 coats, allowing 3 hours between coats.

PREVIOUSLY COATED FLOORS

Apply 2 coats, allowing 3 hours between coats.

STAINING BARE TIMBER FLOORS

1. If staining is required, apply 1 coat of CFP Floor Water Based as a sealer.

2. Apply 1 - 2 coats of Cabot's Stain & Varnish Water Based with a 6 - 10mm nap micro-fibre roller.

3. Finish with 2 coats of Cabot’s CFP Floor Water Based following application instructions above.

Note: To stain a previously coated timber floor, sand back to bare timber before staining.

Cabot's Floor Clean is recommended for regular cleaning.

Once your timber floors have become excessively scratched, it's time for a re-coat with Cabot's CFP Floor Water based.

Sheen

Matt
Satin
Gloss

Available sizes

1 LITRE
4 LITRE
10 LITRE

Product Calculator

If you are unsure on how much product you need, please use our product calculator. Please note minimum length/width value is 1 metre and maximum is 50 metres.

1metre
1metre
2coats
Calculate
0 Total SQM
  • 0 SQM
  • 0 Litre