Cabot's Exterior Varnish Stain

Bring your outdoor surfaces to life! This combined semi-transparent stain and varnish is highly durable and provides protection, colour and shine to timber surfaces – without hiding the grain. Exterior durable technology means only three coats are required as opposed to the five or more coats required for some other products.
  • Fast Recoat 2 Hours
  • Dirt & Mould Resistant
  • Water Repellent
  • Water Wash Up
  • UV Protection
  • Areas
    Exterior timber including doors, furniture, trim, windows
  • Clean Up
    Water
  • Sizes
    500ML, 1L, 2L, 4L
  • Sheen
    Semi Gloss
  • Coverage
    12 M2/L
  • Recoat Time
    2 Hours
  • Safety Data Sheet
Preparation

New Bare Timber

To coat new bare timber immediately, scrub damp timber with Cabot’s New Timber Prep, following label instructions. New Timber Prep will draw out tannins and oils quickly from the surface, allowing you to skip the 4-6 weeks weathering process required for new timber. Always follow New Timber Prep with Cabot’s Deck Clean following label instructions. Remove excess water from the surface with squeegee on Cabot’s Deck Prep brush, and allow timber to dry for at least 1 hour. Note: Cooler conditions could slow down the drying time of the timber.

Previously Painted or Varnished Timber

Remove back to bare timber using a paint stripper, or sanding. For exterior surfaces clean with Cabot's Deck Clean following label instructions.

Previously Stained and Oiled Timber

For exterior surfaces clean with Cabot’s Deck Clean following label instructions. Test if the surface is ready for coating by sprinkling water on the timber. If the water beads on the surface, repeat the application of Cabot's Deck Clean. If water is absorbed into timber, it is ready for coating. For a more transparent look, sand timber back to bare before coating.

Weathered and Grey Timber

For best results, sand timber back to fresh substrate. Clean with Cabot's Deck Clean following label instructions.

Apply with Brush, Spray
Application

1. Stir thoroughly with a broad flat paddle before and during use.

2. Apply liberally along the length of the timber including exposed edges and end grain by brush. The initial milky colour helps with even product application, drying to a semi-transparent finish.

3. Apply three coats allowing 2 hours between coats.

Regular inspection of all coated surfaces is recommended. When recoating aged Cabot's Exterior Varnish Stain, if in good condition, lightly sand and clean surfaces, then apply one or more additional coats. If the coating is in poor condition, thoroughly strip the existing coating and prepare as new timber.

Range

Base colours below are available instore to purchase. From these colour bases, you can tint to 100’s of colours. To view our range, view the colour visualiser.

Chocolate Brown
Chocolate Brown
Colonial Baltic
Colonial Baltic
Dark Oak
Dark Oak
Forest Grey
Forest Grey
Jarrah
Jarrah
Light Blue
Light Blue
Light Cedar
Light Cedar
Maple
Maple
Meranti
Meranti
Mustard
Mustard
New Teak
New Teak
Olive Green
Olive Green

All colours displayed on this page show 2 coats on vic ash timber.
Colour varies depending on your timber type. Click on Colour Visualiser button below to view the full range of colours.

Sheen

Semi Gloss

Available sizes

500 ML
1 LITRE
2 LITRE
4 LITRE

Product Calculator

If you are unsure on how much product you need, please use our product calculator. Please note minimum length/width value is 1 metre and maximum is 50 metres.

1metre
1metre
2coats
Calculate
0 Total SQM
  • 0 SQM
  • 0 Litre