Cabot's Interior Stain Oil Based

Cabot's Interior Stain rejuvenates and transforms the colour of interior timber doors, windows, trim and furniture. It must be over coated with Cabot's Cabothane Clear Oil Based or Cabot’s Danish Oil to give the protection and durability required on interior timber.
  • Areas
    Furniture, Interior Timber Doors, Trim, Windows
  • Sizes
    250ML, 1L
  • Coverage
    12 M2/L
  • Safety Data Sheet
Note: Fill nail holes, cracks and other defects with Cabot’s WoodTone Putty after applying the first coat of this product for accurate colour matching. Remove stains, dirt, wax, grease and oil with mineral turpentine. Remove any polish with a suitable floor polish remover.
Bare Timber
Sand the surface smooth using 180 - 240 grit sandpaper. Sand only in the direction of the grain. Remove all traces of sanding dust.
Previously Coated Timber
Completely remove the previous coating using a paint stripper or by sanding. Remove all traces of sanding dust.
IMPORTANT
The natural colour of the timber will affect the finished colour of the stain. The clear coating used to seal the stain may also have some affect on the final colour. Always test the stain on an off cut or concealed part of the actual job before proceeding.
Staining a Floor
For the best method of staining a floor, please refer to the Cabot's Stain & Varnish range.
Apply with Brush, Rag, Roller

1. Stir thoroughly with a broad flat paddle until pigment is mixed in and colour is uniform. Keep well stirred during use. If using more than one can, mix all cans together into a larger container to ensure colour uniformity.
2. Apply with a good quality brush, roller or lint free rag and work the stain evenly into the grain.
3. Allow to set for 2-10 minutes then rub with a clean soft cloth using a circular motion to remove any excess stain and produce an even coloured surface. The intensity of the colour will depend on porosity of timber and the length of time before the stain is wiped off. 

4. Allow 8 hours drying time.
5. Apply Cabot's Cabothane Clear Oil Based or Cabot's Danish Oil as a top coat following label instructions.

Regular inspection of all coated surfaces is recommended.

Once water repellancy has deminished, re-apply the existing topcoat as per label instructions.

If the timber needs re-staining, sand back to bare.

Range

Base colours below are available instore to purchase. From these colour bases, you can tint to 100’s of colours. To view our range, view the colour visualiser.

Acorn
Acorn
Australian Jarrah
Australian Jarrah
Cedar
Cedar
Jarrah
Jarrah
Maple
Maple
Walnut
Walnut

All colours displayed on this page show 2 coats on merbau timber.
Colour varies depending on your timber type. Click on Colour Visualiser button below to view the full range of colours.

Available sizes

250 ML
1 LITRE

Product Calculator

If you are unsure on how much product you need, please use our product calculator. Please note minimum length/width value is 1 metre and maximum is 50 metres.

1metre
1metre
2coats
Calculate
0 Total SQM
  • 0 SQM
  • 0 Litre