How to Apply Cabot's CFP Floor Oil Based

What to use: Cabot’s CFP Floor Oil Based

Why you should use it: Highly durable, hard wearing finish for interior timber floors.

How it works: Enhance the natural grain and colour of all timber flooring.

Get Started

Bare timber
Sand the surface smooth using 180 - 240 grit sandpaper. Sand only in the direction of the grain. Remove all traces of sanding dust.

Previously coated floors & timber floating floors
Thoroughly clean the surface with Cabot's Floor Clean and allow to dry. Apply one coat to a small test area. Allow to dry for 3 hours. Press sticky tape firmly to the surface and pull off quickly. If the coating comes off, sanding back to a sound surface will be required.
Note: Fill nail holes, cracks and other defects with Cabot's Wood Tone Putty after applying the first coat of this product for accurate colour matching.
Cork flooring
Prepare cork according to cork manufacturers recommendations. Surface must be clean, dry and free of dust, grease or wax. Remove all loose and flaky rotted timber with a wire brush or course (60 grit) sandpaper.
Note: Do not shake can.
1. Stir thoroughly with a broad flat paddle before and during use.
2. Use a brush to cut in around the edge of one section at a time.
3. Apply product with a pad applicator, good quality brush or
6 - 10mm nap roller. Coat along the length of 3 - 4 boards, keeping a wet edge to prevent lap marks.
4. Allow to dry for a minimum of 12 hours. For best results, lightly sand to remove any grain raise using 240 grit paper. Remove all sanding dust.
5. Apply the 2nd & 3rd coats as above.

Apply 3 coats, allowing 12 hours between coats.

Apply 2 coats, allowing 12 hours between coats.

Give your floor time to dry for 16 hours before walking on the newly-coated surface. Replace furniture after 72 hours. 

It’s time to pop those socks on and make like Tom Cruise in Risky Business! Go on – you’ve earned it!